Liczymy pasujące modele…
MN90/99 D90 Rear Roll Bar with and without tire carrier. You'll need to get quite a bit of support for this to all work; but it turned out really well. Both options are included in the file. You'll need 2 x M2 15mm or better to hold the…
WIP - MN90 D90 Front Battery Expansion ("frunk"). The stock part doesn't allow for any good size battery or after market electronics. So I created a set of 3 parts to make it all work. All holes (minus the M3 hole) are sized at 1.95mm so…
Quick push-in radiator for the MN90 series of trucks. I test fit mine on my D90 model and fits very well. The standoffs can be sanded down as need so make sure it fits your truck properly. Print instructions Quite important to print at…
Another way to mount your servo for your MN90/MN99 truck. This is an 'above axle' mount. There are a few different files to help for different servo widths. Choose the one that fits your servo wide best. Note: If you don't see one that…
Two sets of bumpers that fit the stock MN90/99S D90 body. It may fit other similar models, but I only have a D90 to test with. Print instructions Two sets of bumpers that fit the stock MN90/99S D90 body. These may fit other similar…
MN90/99 front chassis plate upgrade. No mods to the stock chassis rails are needed. Uses only 11 grams of plastic when printed at 0.2 and 20% infill. The stock screws for mounting the body can be used. This chassis plate requires a 17g or…
MN90/99 rear chassis plate upgrade. Uses 4 x M3 screws (8mm or 10mm will work). No mods to the stock chassis rails are needed. Uses only 11.4 grams of plastic when printed at 0.2 and 15% infill. The stock screws into the body posts…
I designed this stand trying to do it both material-efficient and as stable as possible. i wanted to do it printable all in one peace. It uses the front and rear axles to provide a safe stand for your MN90 and MN99 RC model. Im not shure…
Rear Magnetic Body Mount kit with option for an extra enforcement. Allows for the rear body mounts to be magnetic only or use the stock screws into the existing supports. Does require you remove (if present) the one extra stand-off on the…
Low load stering arm needed for a rc 3d printed boat servo Printed at 100% infil, because its so small and prints fast anyway Might need supports under the geared fixation point to print prettier, but since that place is covered by a…
Reusing stock brushed engine from my mn90 crawler in a rc boat build. This adapter fits onto engine driveshaft gear almost airtight and allows to mount a prop shaft to it. Printed at 80% infill, .12 resolution. The end is thinner, because…
I designed this stand trying to do it both material-efficient and as stable as possible. i wanted to do it printable all in one peace. It uses the front and rear axles to provide a safe stand for your MN90 and MN99 RC model. Im not shure…
