IKEA ELLOVEN Stacking Adapters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapters to stack a pair of IKEA ELLOVEN drawers.
- Ocena
- 4 / 5
- Polubienia
- 7
- Pobrania
- 67
- Wydruki
- 1
- Wyświetlenia
- 1353
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
We repurposed a pair of IKEA ELLOVEN monitor risers into storage drawers in our small kitchen for small items. The only issue is the Elloven isn't very stack friendly due to it's sheet metal design.
These will solve that issue as well as raise up the drawers slightly (bottom drawer by 20 mm and the top by 5 mm). I probably over engineered them, but they definitely work as intended.
Printed in Prusa silver PLA @ 20% infill without issues. The front parts can be printed without supports on their side; However, the rear corners need to be printed with supports enabled. The rear pieces have a small lip that requires a bit of force to sec it to the bottom drawer. This should also keep them from sliding.
Gcode file included is for a full set (2 front, 2 back) sliced with organic supports and 3 perimeters.