Sofirn SP10Pro Diffuser Cap (vase mode)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, easy, fast printing light diffuser cap/lantern for the SP10Pro.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a simple, easy, fast printing light diffuser for the SP10Pro. Friction fit on the head as per my light. Easy to scale up/down a little for clearances.
I've included 2 files, one straight off the diameter of the light plus 1.6mm for both (0.8mm)walls, and one that adds the 0.25mm(inclusive) that my printer is off in x/y. Print just the bottom 10mm of either and you can get a fast easy test fit for scaling up/down.
Added an extension on the end with a tube for a lanyard. In my slice(Cura 4.8) it Almost closes the inner top of the tube, and only glitches a few strings over one hole, its easy to clean up after.
Round bumps were to stiffen the walls while printed single layer( but at 0.8 it hardly needs it. )
Modeled and designed to run in vase mode/spiralized outer contour at 0.8mm walls(Runs from a 0.4mm nozzle just fine for me). I sliced at 0.3mm layers, and printed in Sunlu white PETG, but anything fairly translucent should be fine.
As I have time I might add other files set for different wall thicknesses, interested, let me know?