Sofirn SP10Pro Diffuser Cap (vase mode)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple, easy, fast printing light diffuser cap/lantern for the SP10Pro.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 11
- Makes
- 0
- Views
- 222
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a simple, easy, fast printing light diffuser for the SP10Pro. Friction fit on the head as per my light. Easy to scale up/down a little for clearances.
I've included 2 files, one straight off the diameter of the light plus 1.6mm for both (0.8mm)walls, and one that adds the 0.25mm(inclusive) that my printer is off in x/y. Print just the bottom 10mm of either and you can get a fast easy test fit for scaling up/down.
Added an extension on the end with a tube for a lanyard. In my slice(Cura 4.8) it Almost closes the inner top of the tube, and only glitches a few strings over one hole, its easy to clean up after.
Round bumps were to stiffen the walls while printed single layer( but at 0.8 it hardly needs it. )
Modeled and designed to run in vase mode/spiralized outer contour at 0.8mm walls(Runs from a 0.4mm nozzle just fine for me). I sliced at 0.3mm layers, and printed in Sunlu white PETG, but anything fairly translucent should be fine.
As I have time I might add other files set for different wall thicknesses, interested, let me know?