Anycubic MegaX x-axis belt tensioner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a belt tensioner for the X-axis used with ANYCUBIC MEGAX. It will probably work with the CHIRON as well. This…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 105
- Wydruki
- 0
- Wyświetlenia
- 911
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a belt tensioner for the X-axis used with ANYCUBIC MEGAX.
It will probably work with the CHIRON as well.
This is the easiest belt tensioner to install in my opinion.
Simply attach the belt clips to the ends of the left and right belts and thread them through the unit.
Just put it over the carriage and tighten the screws.
You will need M3 nuts and M3 screws of the required length.
You may be able to use other models as long as the shape of the belt holder matches.
If you have tried it and found it works, please leave a comment.
update 2021/08/07
To increase the strength of the belt_clip, we increased the thickness of the back by 0.5mm. Also, the position of the nut was moved to the center.
belt_clip-L_v2.stl
belt_clip-R_v2.stl
To increase the strength of the belt_clip when printing, please print the belt_clip with 100% infill so that the clip faces vertically in the stacking direction.
update 2021/09/01
Fixed a bug where the BASE parts were not strong enough to spread out to the left and right.
In older versions, the slit was widened so that clip parts could be attached from the front, but the clearance caused the clip parts to spread and the base parts to spread.
The corrected new version has thicker walls and reduced the clearance to prevent the clips from spreading.
base-L_v2.stl
base-R_v2.stl
It is recommended to print with 100% infill to increase strength
Sorry, we have not yet solved the problem of not being able to press the X-end switch when using the stock carriage.
update 2022/02/15
We have prepared a mount to offset the position of the X-end switch to the position where it makes contact with the base-R.
However, since the X-end switch moves 9mm to the right, the printing range becomes a little narrower.
You may need to adjust the movement range in the firmware.
x-end-switch-mount v2.stl
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
40
Filament: NA PETG BLACK Custom Section ==============
Category: 3D Printer Parts