Officer Insignia - O-6 (Colonel/Captain)

Also known as the “Full Bird”!  The head of this eagle faces it's right, towards the Olive branches in it's right talon to symbolize always seeking peace but holds arrows in it's left talons to show preparation for war.  The one's who've worn this rank are everywhere you'd expect and not expect; both in and out military affairs.

Like my other military designs, this one is meant to be place on flat surfaces.  If you're skilled enough, you'll find a way to manipulate this design to work on anything other than flat surfaces.  See the pictures of this 3D rank insignia printed out.

This model should print decently with the perimeters stated below.  Please note, these below perimeters are from using Ultimaker's Cura slicing program:

Nozzle Tip:  02-04

Quality:  Detailed or higher

Print Wall:  Use (4) layer counts which works best with this design on FDM printers.  

--Use “Optimize Wall Printer Order”

--Use “Wall Ordering”:  Inside-To-Outside

Print Top/Bottom:  See Below!

--Top:  4-6 count works best.

--Bottom:  3-4 count works best.

Print Infill:  

--Infill Density:  15-20%

--Infill Pattern:  LINE 

Print Speed:  40-60 mm/s

Print Travel:  See Below!

--Enable Retraction:  YES

--Retract at Layer Change:  YES

--Z-Hop When Retracting:  YES

--Z-Hop Height:  0.5 to 0.7

NO SUPPORTS NEEDED!  Be mindful of using any Bed Adhesion (skirts, brims, and rafts) on your printer bed due to the size of this design!

Shoutout to all the “Full Birds” making it happen behind the scenes for our country and the troops!