TP-Link Tapo C200 / C210 inverted camera mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix with stronger base and camera clip added to top
- Ocena
- 4,9 / 5
- Polubienia
- 55
- Pobrania
- 611
- Wydruki
- 11
- Wyświetlenia
- 3394
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
TP-Link Tapo Camera Inverted Mount
This is a remix / mashup of Kadows' upside-down Tapo camera stand and Cewo's Tapo base (https://www.printables.com/model/377139-tapo-base-c210).
Design
I printed the orignal but found that the stand was too weak and flexed, so I redesigned it to stronger and have better attachment to the holder.
I also didn't want to use screws etc, so I mashed up the holder with Cewo's tapo base so that no additional hardware is required to mount the camera. I also cut away the area under the tabs so as to make it easier to remove supports.
Printing
I printed with PLA at 0.2mm layers and 15% infill and found it to be strong enough. Supports are only required under the tabs where the camera attaches.