BLTouch and CRTouch for Front 4010 Fan Adjustable Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adjustable BLTouch or CRTouch mount for front of 4010 fan with wire clamp.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 380
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is an old design I made and still use on my ender 3 but it should be usable on any printer with a front mounted 4010 hot end cooling fan. It is adjustable by simply sliding it down and tightening the bolts. You can see it in my picture mounted to the bottom two bolts of my ender 3 pro.
The mount includes a small plate with two holes so you an run the BLTouch wiring and tie it with some small (harbor freight) zip ties.
Parts are small but should print find with no support. You will need two of the spacers. I made mine in PETG but ABS and even PLA should work. PLA would not be recommended for an enclosure but keep in mind this is front of the cooling fan so it will have good airflow and cooling.
The BLTouch offset for my Ender Pro printer that uses a Hydra mount system is x=0 Y=-45 but yours will likely be different.
20250706 I now added a first CRTouch version of the mount. Still not sure where to put a bracket for the cable so I included one with-out it and one with one but I'm open to any ideas.