1 / 4
Mondrian Lamp with paper panes and mains voltage — zdjęcie 1
1 / 4

Mondrian Lamp with paper panes and mains voltage

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of Chris amazing Mondrian Table Lamp. Panes are printed by a regular 2D multi color printer on paper.

Ocena
0 / 5
Polubienia
60
Pobrania
96
Wydruki
0
Wyświetlenia
853
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Construction Manual

First of all. This is inspired by Chris awesome Mondrian Table Lamp heavily. Therefore I mark this as a remake. He uses 3D printing all the way. As I don't have that many filament colors, my design uses a quite common 2D printer to create the panes.

Anyway: Give him a like, a download or build his awesome design instead!

Required Parts

The lamp consists out of

  • 1 base frame (3D print)
  • 1 top frame (3D print)
  • 4 side panels/frames (3D print)
  • 4 inlay frames (3D print)
  • 1 GU10 socket you can buy on Amazon, Ebay, etc.
  • 1 GU10 lamp. I used one from Philips. Colortemperature is Warm-White. You can use other GU10 Lamps as well
  • 1 power cord with an included switch like this one.
  • 2 luster terminals. You can use Wago terminals as well of course.
  • 1 A4 paper and a printer. Print the Pattern.pdf file. The printer settings must not adapt the size of the print! Otherwise it will not fit to the 3D prints. Check the print settings.

Assembly

1. Create the panes

Cut out the four panes you 2D printed. The outer line of the print is where you have to cut.

Place the piece of paper inside the frame. Snap in the frame inlay above the panes. All print faces should point downwards. Then everything alligns correctly. Repeat this step till you assemblied all four frames.

Starting SituationInstert paperSnap In InlayAssembly

2. Create the lampshade

Now you use the four frames you created earlier. Push the for frames into the top frame. If your tolerances are fine, the part should have a good fit. If not, you have to use a bit of glue or sandpaper. If you want to make the lamp more permanent, you can use glue as well. Make sure the part fit well beforehand.

3. Wire the base

Take the GU10 socket and pull the cables through the recess in the cylinder. Afterward you push the GU10 socket in place. If the socket is too loose, you can fix it with the help of an M3 screw and a nut. To do this, you can insert the nut on the backside of the base.

Insert the power cord and pull it through the hole. Afterwards you can connect the GU10 socket and the power cord with the help of luster or Wago terminals. If you don't know how to to this, ask friends who are familiar with electrics and mains voltages. ALWAYS unplug the power cable before working on the lamp! Also create a cable relief with zip ties.

In the end the result should look like this.

4. Combine base and lampshade

Push the lampshade into the base frame carefully! This step is a bit tricky. Push down all four frames properly. The top planes should allign perfectly. Result looks like this.

5. Final step

Push the lid on top of the lamp top frame and you are done.

Tagi