1 / 1
RV vent screen holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a way to hold RV vent screens in place for your heater.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (11)Powiązane
This model is designed to hold the round insect screens in place over your heater vent without having to use the frustrating little spring clips.
Materials: Choose a heat, UV, and chemical resistant material. Tested with PETG.
Instructions:
- Support recommended
- Choose settings that work well with your printer and material choice
- Insert screens in adapter before installing. They will be a fairly tight fit but should fully clear the base plate.
- Remove the screws used to hold your cover plate in place (do not remove the cover plate)
- Make sure your screws will seal when reinserted. You may need to add additional sealant.
- Put screws through provided holes in bracket and install over existing plate.
- It is recommended that you install opposing corner screws first in case of imperfect screw hole alignment.
Edit 5/23/23: Added a revised model with better clearance for heat from top vent. Please note, the plastic may still melt if you run the heat with this attached.