Logitech Litra Glow Mount + Model
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use this mount to design and fit your Logitech Litra Glow to anything.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 797
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Just got myself the new Logitech Litra Glow, which is an awesome little device!
Only issue I had was that original hook stand doesn't sit too well with my monitor back because the back isn't flat, so I designed a base mount unit which can hug the light tile and retain access to the controls on the back.
Use this to create whatever custom mounts or accessories for the Litra Glow, and make sure you post the remixes!
(I've also included a 3D model of the actual light tile with the dimensions I measured and used to create the new mount)
Notes:
- I haven't tested this print using a single infill % so can't say how weak/strong it is if you take that path. Rather I used Cura to configure different infill settings for the base and the prongs.
- Base = 20% infill
- Prongs = 80% infill after the half-way point (For added strength)
Print Settings
- No Supports
- Mixed Infill