Bambu Lab X1 LED Light Frame Front Switch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Latching switch for front right end post
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 1794
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
The touch dimmer switch in the original model was overheating and would not work after a few minutes. I suspect the switch is unable to handle the current draw of COB lights (24V @ 15W).
I also wanted the switch near the front to make it easily accessible.
I ended up remixing endpost_B to add a 12mm diameter hole for a latching switch with no dimmer function. Reason is because a lot of the dimmer switches are unreliable and I usually like the light on at full brightness to inspect print conditions.
Here's the switch I used: https://www.amazon.com/dp/B08LV5DWLG
The switch wiring is straight-forward - it comes with a wiring diagram in the package.
I wired mine so that the ring around the button comes on when the light is on. You can wire it to always have it on.
Note: simply mirror the model to put it on the left side instead of the right side.