1 / 4
Ratcheted Toothpaste Tube Squeezer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print, easy to assemble, easy to use ratchet toothpaste tube squeezer. Click, click, click, brush!
- Ocena
- 4,943 / 5
- Polubienia
- 239
- Pobrania
- 1928
- Wydruki
- 43
- Wyświetlenia
- 5294
- Oceny
- 35
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 43) (Komentarze: 50)Remiksy (2)Kolekcje (298)Powiązane
I loved the concept behind Luke's 3D's original model but it didn't fit my daughter's toothpaste. I also found the model quite hard to assemble as the tolerances were tight and there was little to no horizontal expansion (elephant's foot) compensation built in.
So while I was lengthening the model I decided to make the following improvements:
- Increased shaft and body length by 10mm
- Increased tube slot width on the shaft and body slightly
- Added chamfer to all surfaces that touch the build plate to compensate for horizontal expansion
- Added a bump on the shaft to prevent the tip from coming out while removing the tube
- Stiffened up the ratchet arms
- Improved aesthetics (subjective :))
- Less post processing is required for assembly
Get your Prusameters… Post your Makes!
If you like this project, please don't forget to ❤ Like and ★ Rate!
Printing tips
I've been printing the bodies in PLA and the handle, ratchet, and shaft in PETG.
- 0.4mm nozzle
- 0.2mm layer height
- Support is not required
- Print as shown in the attached screenshot (widest flat faces touching build plate)