Garmin belt clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wear your bicycle computer when you are not biking. Like on hiking, navigating a new town or when just logging a walk.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 131
- Wydruki
- 0
- Wyświetlenia
- 786
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
Garmin compatible quarter turn belt clip mount.
It consists of two models. The clip and the mount.
Mount comes in two different variants. First the “original” looking one, it flexes too much with PETG though, so I designed another variant with less flex. I recommend this one if you don't have some sturdier filament.
Printing tips
Clip is printed standing.
Mount is printed laying. It is slight difficult to print perfect with PETG. Without supports you might get some extra material, just cut away with a knife. Be sure to remove all excess material so you don't damage you bike computer!
Afterwards inspect the edge on the mount, it must be geometrically perfect to fit in mount. Might need to sand just a little. Then press the mount into the clip, it should require slight force but not too much. Look from side if the clip is bent, if it is, trim the mount edges some more and also inspect mating edges on the clip.
Have tried printing with support also but that was not so much better, removing the supports damages the flange also. So just print it without support, I find it best.
My preference is wearing the computer “up side down” so it is readable in place when you fold it just a little. Then the buttons are on top as well.
