1 / 2
Kailh Choc Ergonomic Sculpted Keycaps
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ergonomic sculpted keycaps for choc v1 key switch
- Ocena
- 5 / 5
- Polubienia
- 255
- Pobrania
- 840
- Wydruki
- 7
- Wyświetlenia
- 13 335
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 7) (Komentarze: 19)Remiksy (5)Kolekcje (334)Powiązane
Ergonomic keycaps for Kailh choc v1 key switches.
I designed these keycaps to be used for keyboards with three rows configurations (cantor remix in my case) but should also works great on keyboards with similar configuration. Support is included in the design and can be easily remove by clipping it using nail clipper.
I designed them be easily printable on FDM 3d printers and the print orientation is optimized for both best surface finish and best stem strength in mind without needing any post processing.
Print Tips:
- I am using 0.5 nozzle on my setup, so You may need to adjust your line width to 0.5 mm
- 0.12 mm layer height (0.2 mm first layer height)
- Printable without any raft or brim (You need to have a good layer adhesion for this to work)
- You may need to slow down print speed and/or set z hop if your print pop up from build plate during printing
- You may need to adjust print flow rate a little bit if the stem is either too loose or too tight
- Print sequentially (one by one) for best result
- Place seams on the bottom side of the keycaps