1 / 5
Braided Chopstick Holder (No Supports Required)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An elegant braided design of a holder to keep your chopsticks off the table; designed for print without supports.
- Ocena
- 5 / 5
- Polubienia
- 68
- Pobrania
- 77
- Wydruki
- 3
- Wyświetlenia
- 476
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 3) (Komentarze: 3)Remiksy (1)Kolekcje (59)Powiązane
A beautiful chopstick holder using a braided design which holds an elegant rest in the air, carefully designed so that the model can be print in place without requiring any supports.
Printing notes:
- I used a .20 mm layer height, but other layer heights should work fine as well
- Add a color change before and after the center “rest" for a nice look
- Place it on either the left or right end in the slicer for proper print orientation (see picture)
- Recommend adding a brim in the slicer (I used a 10 mm brim, just to make sure it wouldn't slide around)
- Optionally set the “vertical perimeters” setting to at least 4
- Model is 6 cm long and 2 cm high
I'm attaching the 3MF file that shows the slice settings I used if you'd like to start with that (which match the above notes), as well as the “gcode” I used to print this on my Prusa Mini.
I hope you enjoy, and look forward to seeing other's makes!