Voron V0.2 Z Endstop Reinforcement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Helps the z endstop on the V0.2 be a bit more stable.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 944
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Hey everyone!
So I was having issues where the constant homing of the bed would tap the Z endstop and slide it down ever so slightly. After several homing sequences it would slide it down far enough that it messed up my z height and it would create a gap between the switch and the rail. So I decided to create this simple piece that just slides into the extrusion, screws into the threaded hole at the end and gives it a little bit more support. There is no need to disassemble anything it just slides into place from the bottom.
Hardware: 1x M3x8(it can be longer)