A bee for your honeycomb storage wall (HSW)!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple decorative bee for the honeycomb wall storage system. No MMU required.
- Ocena
- 5 / 5
- Polubienia
- 345
- Pobrania
- 769
- Wydruki
- 17
- Wyświetlenia
- 3774
- Oceny
- 16
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution
A simple remix of the HSW insert, but i think it looks adorable. No Honeycomb storage wall should be without one! No MMU needed, just a few simple manual filament swaps (explained below).
I mounted the design from https://www.thingiverse.com/thing:3488699 on an insert that fits in the HSW.
There are two different files, one with a single bee, or a batch of 5 (for fewer changes) ; it's easy to modify in prusaslicer (i used 2.5.0) if you want to print a plate full. I also provided presliced files for PLA and PETG, either should work fine; I used PETG.
You need the following colors:
- tool 0: white
- tool 1: yellow
- tool 2: black or dark grey
When printing, this will print without an MMU, and uses M600 commands to prompt for a new color that you manually change: the printer (MK3S in my case) will pause and have a normal filament change with the usual unload/load prompts.
When printing, the sequence will be:
- 0 / white (wings; right after the prime line)
- 1 / yellow (body)
- 2 / black (outlines for 1st and 2nd layer)
- 0 / white (wings 2nd layer)
- 1 / yellow (body 2nd layer)
- 2 / black rest of the print)
The color changes happen in the beginning for the print, so it only takes a little bit of time to go through these changes until you can leave the printer alone to finish the print.