Tycoon Max EVA 3 parts for the X belt system
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Customized parts to allow the EVA 3 hot end system to be used with the Tycoon Max X belt
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 560
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to replace the stock hot end on the Tycoon max, lets face is it's not very good. I reworked some parts from the EVA 3 system so I can use the X belt system on the tycoon max. Extended the horn and top mounts too.
One thing to note on this conversion. It will require a lot of changes to the firmware so unless you're happy to compile Marlin I would recommend Klipper, but then Klipper will not work with the clone BL touch on the tycoon so it would need on original to work. You can run Klipper on the board in the max.
This is the firmware that worked for me
https://github.com/makerbase-mks/Klipper-for-MKS-Boards/tree/main/MKS%20Robin%20Nano%20V2.x
I had to change the bl touch position, the min and max X values and the max Z as well as the setup for the Orbiter Extruder and new hot end.