2020 extrusion mounting plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a wall or bench mounting plate for 20x20 v-slot aluminum extrusion.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 128
- Wydruki
- 0
- Wyświetlenia
- 693
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wall or bench mounting plate for 20x20 v-slot aluminum extrusion. Has a v-shaped wedge to help with centering/stability. To fasten to your extrusion use M3 screws and the usual hardware. I recently discovered these nifty roll-in T-nut pieces which you can insert into the channel without sliding in from the end. The screw hole is recessed so the head won't scratch the wall/bench. When used with the T-nuts above an M3x8mm cap screw fits perfectly.
The other holes are also recessed but are a bit larger (around M5) so you can use standard wall fasteners.
Prints easily with minimal support (two tiny supports underneath the recessed screw holes).