Adafruit Anemometer 1/4-20 adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter plate to allow you to mount the anenometer with a 1/4-20 bolt. Useful if using photo clamps, magmounts, etc.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 487
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I picked up this anemometer from Adafruit: https://www.adafruit.com/product/1733
I plan on using a magmount adapter with a 1/4-20 screw to mount it. The anemometer base has four screw holes, so I made an adapter.
The hole for the 1/4-20 is designed to take a 1/4-20 heatset insert: http://amzn.to/2Ay4NDZ
For attaching to the anemometer base you can either use long M5 screws/bolts or you can use an M5-0.8 heatset insert like this: http://amzn.to/2ASFF7R
I've included two versions of this design. The version with the riser is if you use screws/nuts to attach the anemometer. The riser gives you room for your screw heads. The flush version is if you use the heatset inserts. I like the inserts because the installation is cleaner, but your mileage may vary.
I'll be surprised if more than 5 people need this, but I like to share. The design prints clean...with my Lulz Mini using Cura it took about 40 minutes to print.
Print Settings
Printer Brand:
LulzBot
Printer:
Mini
Rafts:
No
Supports:
No
Resolution:
I did 0.38mm
Infill:
20% worked
Notes:
Prints clean and comes off the bed reasonably easily.
Category: Electronics