Adafruit Anemometer 1/4-20 adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter plate to allow you to mount the anenometer with a 1/4-20 bolt. Useful if using photo clamps, magmounts, etc.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 25
- Makes
- 0
- Views
- 487
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I picked up this anemometer from Adafruit: https://www.adafruit.com/product/1733
I plan on using a magmount adapter with a 1/4-20 screw to mount it. The anemometer base has four screw holes, so I made an adapter.
The hole for the 1/4-20 is designed to take a 1/4-20 heatset insert: http://amzn.to/2Ay4NDZ
For attaching to the anemometer base you can either use long M5 screws/bolts or you can use an M5-0.8 heatset insert like this: http://amzn.to/2ASFF7R
I've included two versions of this design. The version with the riser is if you use screws/nuts to attach the anemometer. The riser gives you room for your screw heads. The flush version is if you use the heatset inserts. I like the inserts because the installation is cleaner, but your mileage may vary.
I'll be surprised if more than 5 people need this, but I like to share. The design prints clean...with my Lulz Mini using Cura it took about 40 minutes to print.
Print Settings
Printer Brand:
LulzBot
Printer:
Mini
Rafts:
No
Supports:
No
Resolution:
I did 0.38mm
Infill:
20% worked
Notes:
Prints clean and comes off the bed reasonably easily.
Category: Electronics