1 / 3
SD Card Holder with mounting flanges
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
At work I have a rack full of recorders which take SDHC cards. Made this to hold cards. Fastens to a blank rack plate.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
At work I have a rack full of recorders which take SDHC cards. I needed an SDHC card holder that I could fasten to a 1RU rack panel. Threw this together with a combination of OpenSCAD and Tinkercad smashing. It's angled slightly to keep the cards from falling out, and there's an interior wedge which makes the cards stick out a bit relative to one another so you can pull them out easier.
Prints clean with no supports if oriented in the obvious direction.