Riser stand for darkOne tray with FrSky X12S TX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The tray riser prevents TX connector/cable damage during programming of FrSky 12XS with darkOne TX tray.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
The tray riser prevents TX connector/cable damage during programming of FrSky 12XS with darkOne TX tray.
As the tray original rear bottom supports are only glued to the base, there can be dimensional inaccuracy. The raiser left and right parts are fixed by click-on to the tray alu tubes, not to the bottom supports, there must be enough space for the supports to fit in freely.
You can either print a draft prototype, test and modify the source, or (quick and dirty) print as is and fine-tune with a deburr tool.
Not intended to fit in the TX transport case when attached.
Print instructions
Infill 15%
Support on build plate only