Sur-Ron Extended Rear Fender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extended rear fender for the surron lightbee or segway x260
- Ocena
- 4 / 5
- Polubienia
- 11
- Pobrania
- 169
- Wydruki
- 1
- Wyświetlenia
- 1972
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is my third revision of an extended rear fender for the Surron (or Segway x260). The stock seat fender doesnt block very much mud. It is also one of the first pieces to break when you mess up a wheelie.
This model is two pieces, one is the under seat mounted piece, and the other is a long tail. It uses the maximum width of a Prusa MK3s print bed. Rather than design a shorter variant, I opted to just let people cut shorter if they desier.
The pictures are from version 2 of my design, where I was using a different mounting method for the tail. I had the v2 mount break in a few places. In version 3, ive moved to a dovetail joint which has been good so far.
I printed both models at 8% infill and used 4 perimeters for more strength. Supports are needed on the seat mount piece. I used organic supports in prusa slicer and they removed very easily.