1 / 3
Imporoved mount for Sigma Sport STS Speed Transmitter — zdjęcie 1
1 / 3

Imporoved mount for Sigma Sport STS Speed Transmitter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The included mount for the Sigma STS Speed Transmitter does not work well on some forks, this aims to improve that.

Ocena
0 / 5
Polubienia
2
Pobrania
17
Wydruki
0
Wyświetlenia
233
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This simply replaces the included mount from the Sigma Sport STS Speed Transmitter, since this does not work well on forks that are somewhat pointy.

It can simply be attached to the inside of the fork using zip ties (run through the guides on the top and bottom) and a bit of rubber/silicone between mount and fork to stop any sliding.

The transmitter is mounted by either tapping an M3 thread in the plastic cylinder or using a nut. Then an M3 screw and a toothed lock washer can be used to attach the protruding bit of the transmitter to the short side of the cylinder.

It is recommended to print using PETG or similar to provide some flexibility to the baseplate, as PLA might snap when conforming to a slightly rounded fork.

 

Tagi