Imporoved mount for Sigma Sport STS Speed Transmitter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The included mount for the Sigma STS Speed Transmitter does not work well on some forks, this aims to improve that.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 233
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
This simply replaces the included mount from the Sigma Sport STS Speed Transmitter, since this does not work well on forks that are somewhat pointy.
It can simply be attached to the inside of the fork using zip ties (run through the guides on the top and bottom) and a bit of rubber/silicone between mount and fork to stop any sliding.
The transmitter is mounted by either tapping an M3 thread in the plastic cylinder or using a nut. Then an M3 screw and a toothed lock washer can be used to attach the protruding bit of the transmitter to the short side of the cylinder.
It is recommended to print using PETG or similar to provide some flexibility to the baseplate, as PLA might snap when conforming to a slightly rounded fork.