1 / 1
Display stand for KiMe — zdjęcie 1

Display stand for KiMe

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This stand provides an alternative mounting option in case the KiMe sculpture is not directly attachted to the wall.

Ocena
0 / 5
Polubienia
8
Pobrania
97
Wydruki
0
Wyświetlenia
894
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

01. Introduction

This model is an alternative mounting option for the KiMe kinetic sculpture. Once mounted on this stand, the entire sculpture can be leaned against the wall at a slight angle.

02. Parts & Printing

In addition to the three files provided, you will need a wooden slat of 20x40mm in cross section and 2m in length to complete this construction. To attach the sculpture to the stand you will need a screw insert or two nuts (and washers) along with a rod (M8x110mm) as described in the KiMe manual.

The wooden slat needs to be cut into 3 pieces: Two pieces 550mm long and one piece 900mm long. The center of the 8mm hole for the rod should be drilled about 25mm from the top of the 900mm piece to be located exactly in the center of the stand.

For the printed parts, I used Amazon Basic PLA with the following settings:

  • Layer height: 0.2mm 
  • Perimeters: 3
  • Infill: 20%

Ensure that the parts are positioned on the build plate with the screw holes facing down.

03. Assembly

To assemble, simply push the wooden pieces into the printed parts as shown in the illustration below. The printed parts should be tight enough so that nothing comes loose. However, to be on the safe side, there are holes on the back of the printed parts. I personally didn't need them though.