Display stand for KiMe
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This stand provides an alternative mounting option in case the KiMe sculpture is not directly attachted to the wall.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 97
- Makes
- 0
- Views
- 894
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
01. Introduction
This model is an alternative mounting option for the KiMe kinetic sculpture. Once mounted on this stand, the entire sculpture can be leaned against the wall at a slight angle.
02. Parts & Printing
In addition to the three files provided, you will need a wooden slat of 20x40mm in cross section and 2m in length to complete this construction. To attach the sculpture to the stand you will need a screw insert or two nuts (and washers) along with a rod (M8x110mm) as described in the KiMe manual.
The wooden slat needs to be cut into 3 pieces: Two pieces 550mm long and one piece 900mm long. The center of the 8mm hole for the rod should be drilled about 25mm from the top of the 900mm piece to be located exactly in the center of the stand.
For the printed parts, I used Amazon Basic PLA with the following settings:
- Layer height: 0.2mm
- Perimeters: 3
- Infill: 20%
Ensure that the parts are positioned on the build plate with the screw holes facing down.
03. Assembly
To assemble, simply push the wooden pieces into the printed parts as shown in the illustration below. The printed parts should be tight enough so that nothing comes loose. However, to be on the safe side, there are holes on the back of the printed parts. I personally didn't need them though.
