Cable Strain Relief for Voron for Formbot cable chain(3 hole) mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Formbot kit's cable chain chews through wires. So I went umbilical, and designed this to attach to cable chain mount
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 585
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
NOTE2: It finished printing, and I installed it. Couple problems I had are that the holes are about .5mm too wide, so the head of the screw sits into the hole a little. I think button head screws would be fine. I used socket head. If you don't feel like editing the file, then just use some washers. Also, there's a notch I had put in for the screw head. Well I think another .5mm notch may have been necessary below that, because it was snug against the existing part. I just scraped it and it was perfect. But I think you might be able to mount it without making that change. I didn't update the file with any of these changes, but you are welcome to.
NOTE: This is currently printing, so I haven't tested. I just wanted to go ahead and upload in case I forget to do it later. I also included the f3d file in case anyone wants to change it.
The Formbot kit's cable chain chews through wires. So I went umbilical, and designed this to attach to cable chain mount. This holds the cables so they aren't moving around a lot closer to the hotend, which would be harder to repair if there was a break. Also the strain relief reduces the chances of one of those wires snagging on something.