Cable Strain Relief for Voron for Formbot cable chain(3 hole) mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Formbot kit's cable chain chews through wires. So I went umbilical, and designed this to attach to cable chain mount
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 32
- Makes
- 0
- Views
- 585
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
NOTE2: It finished printing, and I installed it. Couple problems I had are that the holes are about .5mm too wide, so the head of the screw sits into the hole a little. I think button head screws would be fine. I used socket head. If you don't feel like editing the file, then just use some washers. Also, there's a notch I had put in for the screw head. Well I think another .5mm notch may have been necessary below that, because it was snug against the existing part. I just scraped it and it was perfect. But I think you might be able to mount it without making that change. I didn't update the file with any of these changes, but you are welcome to.
NOTE: This is currently printing, so I haven't tested. I just wanted to go ahead and upload in case I forget to do it later. I also included the f3d file in case anyone wants to change it.
The Formbot kit's cable chain chews through wires. So I went umbilical, and designed this to attach to cable chain mount. This holds the cables so they aren't moving around a lot closer to the hotend, which would be harder to repair if there was a break. Also the strain relief reduces the chances of one of those wires snagging on something.