Caliburn V1 Refresh Cutting, drilling and Hardware Substitute Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parts to help not make building one so suck
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 287
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Parts to help make a caliburn v1 refresh.
Front tube cut jig is to help make the cuts on a 1 ½ tube easier than gluing the paper cutouts on. May have to use some blue tape to hold the tube still while cutting.
The ½ od ¼ id tube is for reinforcement with https://www.mcmaster.com/89495K395/ to replace the ½ rod that has to be drilled in the center, which is hard to do without proper tools. This still needs a 6-32 tap to use it though. Also allows for different colors than the rods that are only certain colors.
Trigger link is meant to help line up the holes for https://www.mcmaster.com/4490T171/. The hole being exactly center does not matter in this case.
PVC stock reinforcer tube is meant to have a 5/8 plastic tube reinforcer. Cutting the cutout section with a flush cutter is easy if your tube is soft enough for it.
Jamdoor with 3 holes is Slug's upgraded jamdoor with the tri hole cutouts from sillys jamdoor.