1 / 3
3 Inch Cinewhoop Duct for Reptile Cloud-149 & HSKRC Brave 163 — zdjęcie 1
1 / 3

3 Inch Cinewhoop Duct for Reptile Cloud-149 & HSKRC Brave 163

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This duct is designed to fit the Cloud-149, 149HD and Brave 163 drone frames

Ocena
0 / 5
Polubienia
3
Pobrania
40
Wydruki
0
Wyświetlenia
409
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

This duct is designed to fit the Cloud-149, 149HD and Brave 163 drone frames (which apparently have the same mounting hole positions).

The inner diameter is 78mm which gives about 1-2mm of prop clearance when using Nazgul Cine 3040 propellers.

This model was created from a tutorial on drone duct design using Fusion 360, the video of which can be watched here:

It is designed to print upside-down and without supports, as all overhangs are 45 degrees or less from vertical.

PETG is the preferred material, though PLA also works pretty well. Other hard materials should be fine, definitely would not print these from TPU or other flexibles as the wall of the duct is too thin, which would make for a very flimsy and squishy duct.

The holes are sized at 1.7mm which should be tight enough to hold onto the original bolts/screws, otherwise drilling out the holes and installing the appropriate brass inserts is recommended.

Notes:

Flip the duct model upside-down in the slicer before printing

Tagi