Yet another NozzleScrubber for Voron Trident without Z-Endstop Pin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Nozzle Scrubber Mod for the Voron Trident without a Z-Endstop Pin.
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 115
- Wydruki
- 0
- Wyświetlenia
- 1595
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
All the models I have found do not fit properly on my Voron Trident. I have built a LDO Trident Kit. This is a Nozzle Scrubber Mod for the Voron Trident without a Z end stop pin.
This model is an adapted version of:
- https://www.printables.com/de/model/201999-nozzle-scrubber-with-a-little-bucket-for-voron-24
The arm is taken from here:
- https://www.printables.com/de/model/367708-nozzle-scrubber-arm-extension-voron-trident-with-n
The idea of the angled version is from here:
- https://www.printables.com/de/model/379644-angled-nozzle-scrubber-for-voron-trident
But the mounting with only one screw is not tight enough.
So I combined the ideas and built a new holder. The brush holder is slightly angled (20°) towards the print bed. With the Trident, the nozzle can't extend far beyond the bed.
The 8mm spacer brings the whole thing a bit higher.
I printed the parts with ABS with the standard Voron print settings.
You need:
- 2 M3x16 SHCS with the spacer or 2 M3x8 SHCS without spacer
- 2 M3 Roll-in T-nuts
- 2 M3 Threaded Inserts (M3x5x4)
- 4 6x3mm Neodimium Magnets