VORON Skirt: RJ45 Jack / Buchse
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Honeycomb Insert for Voron Skirt with RJ45 Jack
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 266
- Wydruki
- 3
- Wyświetlenia
- 2041
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a quicker access for my ADXL345 Board, connected to the Raspberry-Pi under my VOROn 2.4 Printer. So i grabbed a “deleyCON Keystone Jack Modul” from Amazon, designed a Skirtinsert and there we go. Unfortunally, because of the Size of the RJ45 Jack, its not possible to center - but i think its totally fine.
>>> The Print has a Support integrated - just remove the wall after printing.
>>> There are 2 Versions - 1 with rounded corners. It it fits too loose, use this.
This is, what i used on Amazon: https://www.amazon.de/dp/B0BS6XRZ3X
Just grab an old CAT-Cable (No Plug needed!) and install under the Printer to the Mainboard / Raspberry - Outside: take the Cable with Plug installed and solder on to your ADXL. Make sure, to note your PinOuts to prevent checking again and again.
Please share you Makes.
If you like to gift me a coffee i really appreciate it: https://www.paypal.com/paypalme/taunustomas