1 / 4
Anycubic i3 Mega S PTFE Spool Stand — zdjęcie 1
1 / 4

Anycubic i3 Mega S PTFE Spool Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Heavily inspired by the spool holders on Voron printers.

Ocena
5 / 5
Polubienia
8
Pobrania
90
Wydruki
1
Wyświetlenia
830
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Heavily inspired by the spool holders on Voron printers. Never seen PTFE being used for spool holding and I would like to give it a try. Designed to fit 4mm PTFE tubes and the stock I3 Mega S spool holder. My main concern is that the PTFE wouldn't be very wear-resistant, so I would like to try other materials such as polished stainless steel rods in the future. But if the Voron designers chose PTFE there must be a good reason.

Print instructions

Just print both halves (they are slightly different to avoid interference with the holder) and slide them onto the holder. It is a tight fit so don't be afraid to play with scaling and horizontal expansion.

Print with the flat side down, shouldn't need support. Material doesn't matter, I used 0 infill and 3 shells.

Tagi