1 / 4
Anycubic i3 Mega S PTFE Spool Stand — image 1
1 / 4

Anycubic i3 Mega S PTFE Spool Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Heavily inspired by the spool holders on Voron printers.

Rating
5 / 5
Likes
8
Downloads
90
Makes
1
Views
830
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

Heavily inspired by the spool holders on Voron printers. Never seen PTFE being used for spool holding and I would like to give it a try. Designed to fit 4mm PTFE tubes and the stock I3 Mega S spool holder. My main concern is that the PTFE wouldn't be very wear-resistant, so I would like to try other materials such as polished stainless steel rods in the future. But if the Voron designers chose PTFE there must be a good reason.

Print instructions

Just print both halves (they are slightly different to avoid interference with the holder) and slide them onto the holder. It is a tight fit so don't be afraid to play with scaling and horizontal expansion.

Print with the flat side down, shouldn't need support. Material doesn't matter, I used 0 infill and 3 shells.

Tags