EBB36 mount for Voron Stealthburner (CW2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic EBB36 1.2 mount for Voron Stealthburner (Clockwork 2)
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 403
- Wydruki
- 1
- Wyświetlenia
- 3698
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is my take on EBB36 canbus board holder for Voron Stealthburner. I have taken the model from Kotvic (Thank you!) and pretty much redesigned it to address some issues I have found with the original model:
- Heat inserts holes were too small (4.5mm) - changed to 4.7mm.
- Heat inserts for the clamp were pushing plastic onto the corrugated hose groove making the hose and clamp attachment difficult - fixed by removing the plastic there.
- Raised the EBB36 mount a bit to give more space to the board rear.
- M3 screw holes (thread and head) were a bit small, making the assembly more difficult.
- Due to 3, I had to move the corrugated hose groove up to align with the EBB36 data port.
Print with standard Voron settings.
Unfortunately, If you need a different corrugated hose diameter, there are no user parameters to change in the attached CAD. However, CAD is attached.
Required hardware:
6x M3x8mm BHCS or SHCS screw
4x M3 Threaded Insert (M3x5x4, Voron standard)
This is the hose I used (was the quickest shipping): RANIT 3M/9.8Ft Long Corrugated Tube Black Plastic 10Mm x 7Mm Flexible Corrugated Conduit Pipe Hose Tubing https://a.co/d/iro3RRV (Not an affiliate link)