1 / 1
LACK Enclosure Altered Front-Right lid piece
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick remix of one of the LACK Enclosure parts to accommodate larger screw heads and avoid the pre-drilled leg hole
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 63
- Wydruki
- 1
- Wyświetlenia
- 594
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (21)Powiązane
A quick remix out of necessity . . . when building my LACK enclosure I encountered 2 problems with this particular part.
- The screws I was using had heads which were too large to fit down into the hole on the original part (and . . . weirdly . . . this is the ONLY part affected since none of the others have recessed holes like this one does.)
- The hole closest to the mounting guide material partially overlapped the pre-drilled hole in the table top where the double-ended screw for the leg would go when assembling the table normally, necessitating moving the hole back a bit to accommodate.
I figured I'd publish this in the hopes that it helps others who want to make a LACK table enclosure and run into the same the problems (which . . . honestly . . . is probably MOST people).