1 / 1
LACK Enclosure Altered Front-Right lid piece
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A quick remix of one of the LACK Enclosure parts to accommodate larger screw heads and avoid the pre-drilled leg hole
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 63
- Makes
- 1
- Views
- 594
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
A quick remix out of necessity . . . when building my LACK enclosure I encountered 2 problems with this particular part.
- The screws I was using had heads which were too large to fit down into the hole on the original part (and . . . weirdly . . . this is the ONLY part affected since none of the others have recessed holes like this one does.)
- The hole closest to the mounting guide material partially overlapped the pre-drilled hole in the table top where the double-ended screw for the leg would go when assembling the table normally, necessitating moving the hole back a bit to accommodate.
I figured I'd publish this in the hopes that it helps others who want to make a LACK table enclosure and run into the same the problems (which . . . honestly . . . is probably MOST people).