1 / 3
MTG Mana Companion Cube Deck Box with 6x3 magnets — zdjęcie 1
1 / 3

MTG Mana Companion Cube Deck Box with 6x3 magnets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of MTG Mana Companion cube Double deck/Commander deck box to latch closed with 6mm x 3mm round magnets

Ocena
0 / 5
Polubienia
86
Pobrania
274
Wydruki
0
Wyświetlenia
2270
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Following the basic idea from dolmdemon but only using the original models from n2o1. I remixed this design to use 6mm x 3mm round magnets instead of the 8mm x 3mm round magnets dolmdemon used. My motivation is simply that I have a lot of cheap 6x3 magnets and no 8x3.

I did a few things differently than dolmdemon to get the most out of the smaller 6x3 magnets.

  • Reduced spacing between to magnets to be only 1mm below the surface. Previously 1.5mm and 3mm for box and lid respectively
  • Option to double up magnets in the box, lid, or both. Testing indicated an increase in force 50% when doubling up one and 90% when doubling up both. 6mm x 6mm round magnets would likely have the same effect and would fit the same if you have them.

Unfortunately FreeCAD could not make a solid out of the stl files from n2o1 or dolmdemo. Therefore I did all the remix work in prusaslicer. Therefore there is only 3mf files and no stls. Designed to be sliced at 0.2, 0.15 or 0.1 layer heights.

Tagi