TRS sled for 54mm AV bay Wildman Mach 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a sled designed for an Eggtimer TRS to be used inn a 5 inch 54mm AV bay.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 356
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
The model was designed to house a TRS flight computer/GPS locator in a 5 inch, 54mm AV bay for a Head End Deployment 54mm Wildman Mach 2 Clone.
It has an external rubber duck aerial mounted outside of the AV bay in the nose cone connected by an rp-sma cable the screws through the 54mm bulkhead.
It has one charge well in each end for drogue and main.
It uses 2 x 300mAh Turnigy 3s batteries. One for the computer/GPS and one for the deployment charges. They are countersunk into the sled and secured with plastic braces.
It uses a Fingertech robotics screw Switch for deployment channel activation. There is no switch for the GPS/Flight Computer as it needs to be on before the AV Bay is closed. This meets Tripoli requirements for active channels being shunted until flight ready.
The sled is printed in petg. 0.4mm nozzle, 0.2mm layer height.
The End Caps and Charge wells were printed in PC-Blend for additional heat tolerence and have so far been used on 6 high power flights past 4000ft with no signs of deterioration.
The AV bay is a piece of commercial 54mm fibreglass coupler cut to 5 inches as per the Wildman design