Low-Filament MacBook Air Laptop Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple laptop stand for my 2020 Mac Air; the notches that hold it in place are low enough that you can't feel them on…
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 1965
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Simple laptop stand for my 2020 Mac Air; the notches that hold it in place are low enough that you can't feel them on your wrists when you're using the keyboard. I made to use as little material as possible but not compromise on usability (I made it during the start of the pandemic, when there wasn't any filament stock anywhere). I made this to fit on my Prusa MK2.5 (250mm x 210mm x 200mm build volume) so it might not fit on some printer's build plates
Mirror the file to get both sides and glue two equal lengths of 1/2" PVC into the holes; length is your preference.
PLA at 0.2mm layer height with 3 perimeters and 5%-10% infill was plenty strong for the laptop.