G4 Socket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't want to buy an overpriced G4 socket for my Lack enclosure so I just made one.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 388
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For lighting my Lack enclosure I wanted to use the spare G4 LED bulbs I had laying around. I had these bulbs: https://www.amazon.de/gp/product/B00TTEUGU2
The socket might require removing of the rim for other bulbs as the G4 socket is flat normally.
For contact pins I used ferrules where I removed the plastic cover. They have been pushed in from the bottom. The design is slightly angled. With a little bent on the pin of the bulb, I have a solid contact.
The top I've inserted a cable with ferrules from the side and carefully soldered the ferrules at a 90 degree angle. I printed in PLA. It started to melt a little during soldering (330⁰C) but made contact with the correct part before being short circuit.
BOM
- M3x20 Wood Screw
- 4x ferrules with a outer diameter of about 1.9mm