Ender 3 rear electronics case lid for 90mm fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 670
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua NF-A9x14 PWM, adapting (and later doing from scratch) the electronics lid installed on the back of my Ender 3.
I strengthened the lid to prevent it from bending.
Just pass the fan cable and connect it, then slide the lid and fit the fan in place.
I added the f3d file in case you need to tune it up.
Note: Only tested with Noctua 14mm low profile fan, beware with taller fans as they can hit the bed leveling wheels.
Print instructions
Category: 3D Printer Accessories Summary
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua NF-A9x14 PWM, adapting (and later doing from scratch) the electronics lid installed on the back of my Ender 3.
I strengthened the lid to prevent it from bending.
Just pass the fan cable and connect it, then slide the lid and fit the fan in place.
I added the f3d file in case you need to tune it up.
Note: Only tested with Noctua 14mm low profile fan, beware with taller fans as they can hit the bed leveling wheels.
Print Settings
Printer Brand: Creality
Printer: Ender 3
Rafts: No
Supports: No
Resolution: 0.2