Ender 3 rear electronics case lid for 90mm fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 38
- Makes
- 0
- Views
- 670
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua NF-A9x14 PWM, adapting (and later doing from scratch) the electronics lid installed on the back of my Ender 3.
I strengthened the lid to prevent it from bending.
Just pass the fan cable and connect it, then slide the lid and fit the fan in place.
I added the f3d file in case you need to tune it up.
Note: Only tested with Noctua 14mm low profile fan, beware with taller fans as they can hit the bed leveling wheels.
Print instructions
Category: 3D Printer Accessories Summary
I have problems with my TMC2208 getting hot with a 40mm fan, so I decided to upgrade to the 90mm low profile Noctua NF-A9x14 PWM, adapting (and later doing from scratch) the electronics lid installed on the back of my Ender 3.
I strengthened the lid to prevent it from bending.
Just pass the fan cable and connect it, then slide the lid and fit the fan in place.
I added the f3d file in case you need to tune it up.
Note: Only tested with Noctua 14mm low profile fan, beware with taller fans as they can hit the bed leveling wheels.
Print Settings
Printer Brand: Creality
Printer: Ender 3
Rafts: No
Supports: No
Resolution: 0.2