Mean Well Power Supply LRS-150 IEC Cord, switch, and output terminal housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mean Well Power Supply LRS-150 cover with IEC Cord input, power switch, and output terminals
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 1145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a simple cover for a Mean Well LRS-150 power supply that will hold an IEC power cord adapter, power switch, and output terminals/plugs.
All hardware used to mount the PS and cover is M3. The cover mounting holes are sized for self-tapping screws, but could be drilled out to 4mm to fit M3 heat-set nuts (like I did).
The IEC socket I used is an "Oiyagai 4pcs IEC320 C14 Inlet Module Connector Fuse Switch". The power jack is an "E-outstanding 5-Pack DC-099 5.5 mm x 2.1mm 30V 10A DC Power Jack". The banana jacks are "CenryKay 20pcs Terminal Wire Connectors 4mm Banana Socket". All of these parts were purchased on Amazon.
I printed this in PLA with 100% infill. The "complete" model has the cover installed, which can easily be extracted from the main box with a chisel or X-Acto knife (be careful!). Printing of the "complete" model can be done *without supports* because there are no overhangs. Additional models and the original Blender model is included.
I hope this helps and is interesting. I needed this for a bench-mounted 24V supply, to prevent the 110V input and other wiring from flapping around in the breeze. Feel free to remix, alter, and reprint as you wish. Enjoy!!