1 / 10
Mean Well Power Supply LRS-150 IEC Cord, switch, and output terminal housing — image 1
1 / 10

Mean Well Power Supply LRS-150 IEC Cord, switch, and output terminal housing

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mean Well Power Supply LRS-150 cover with IEC Cord input, power switch, and output terminals

Rating
0 / 5
Likes
6
Downloads
77
Makes
0
Views
1,149
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution

This is a simple cover for a Mean Well LRS-150 power supply that will hold an IEC power cord adapter, power switch, and output terminals/plugs.

All hardware used to mount the PS and cover is M3. The cover mounting holes are sized for self-tapping screws, but could be drilled out to 4mm to fit M3 heat-set nuts (like I did).

The IEC socket I used is an "Oiyagai 4pcs IEC320 C14 Inlet Module Connector Fuse Switch". The power jack is an "E-outstanding 5-Pack DC-099 5.5 mm x 2.1mm 30V 10A DC Power Jack". The banana jacks are "CenryKay 20pcs Terminal Wire Connectors 4mm Banana Socket". All of these parts were purchased on Amazon.

I printed this in PLA with 100% infill. The "complete" model has the cover installed, which can easily be extracted from the main box with a chisel or X-Acto knife (be careful!). Printing of the "complete" model can be done *without supports* because there are no overhangs. Additional models and the original Blender model is included.

I hope this helps and is interesting. I needed this for a bench-mounted 24V supply, to prevent the 110V input and other wiring from flapping around in the breeze. Feel free to remix, alter, and reprint as you wish. Enjoy!!

Tags