Anbernic RG351V Grip, Front Cover, Stand

Grip, front cover and stand for the Anbernic RG351V retro gaming handheld. The grip makes longer gaming session more comfortable without blocking buttons or connectors on the bottom of the device. The front cover protects the screen, top and side mounted buttons, the USB-C ports, the audio jack and the upper SD card slot. The cover can be used while the grip is still mounted to the device and is easy to clip on. The stand lets you put the RG351V on display alongside other devices.

All components can be printed using PLA, but grip and front cover require support. One of the pictures shows the critical areas, where you should add support. The grip doesn’t has much contact area with the build plate, so using an adhesive spray or similar helper might spare a headache. I had good results with the following settings.

Grip:

• Filament: PLA
• Nozzle: 0.4 mm
• Layer Height: 0.2 mm
• Walls: 2
• Top/Bottom Layers: 3
• Infill: 15%
• Support: Yes
• Brim: No
• Cooling: Yes
• Print overhangs with reduced speed

Front Cover:

• Filament: PLA
• Nozzle: 0.4 mm
• Layer Height: 0.2 mm
• Walls: 3
• Top/Bottom Layers: 3
• Infill: 25%
• Support: Yes
• Brim: No
• Cooling: Yes
• Print overhangs with reduced speed

Stand: 

• Filament: PLA
• Nozzle: 0.4 mm
• Layer Height: 0.2 mm
• Walls: 2
• Top/Bottom Layers: 3
• Infill: 15%
• Support: No
• Brim: No
• Cooling: Yes

In case the grip isn’t to your liking, I also uploaded a simplified version of the RG351V. This body double might be helpful to design your own grip. It is a simplified version that spares out the more complex geometry of the shoulder buttons, but otherwise has all the buttons at the right place.