1 / 2
Wireless charging station for Nissan Titan Center Console — zdjęcie 1
1 / 2

Wireless charging station for Nissan Titan Center Console

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a model that I created for the owner of a Nissan Titan that wanted somewhere to charge a phone wirelessly.

Ocena
0 / 5
Polubienia
5
Pobrania
22
Wydruki
0
Wyświetlenia
1152
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

This design is meant to set into the inserts in the center console of the Nissan Titan 2016 and newer. 

The back plate is shaped to hold a Samsung EP-P2400 wireless charger. This is the square model of charger. The front plate creates pockets, the center holds the phone upright and was model to hold the Samsung Note20 Ultra, so it should be able to accommodate just about any phone. As seen in the photos, the right creates a small pocket for items such as pens. The right leave a gap in the bottom to allow the charging cable to pass through. 

This requires taking apart the insert from the center console. It is held together with just a couple screws on the bottom, which will be reused to attach these prints. A Philips head screw driver is all that was needed to disassemble and then reassemble the item. 

Printing:

Since this is in a vehicle, consider your weather when choosing a print material. This test has lasted 6 months in PLA in the mid west USA, but those 6 months were fall and winter. We intend to test spring and summer as well, but a more temperature and sun resistant material may be needed if you are in a warmer area. 

Supports will be necessary on both parts.

If you want a strong print, use more walls, but these parts are thin, so there won't be much infill anyway. Any basic quality settings should do fine. 

To assemble:

Remove the insert from the Titan by lifting it up, out of the center console. 

Locate the screws on the bottom of the insert. There should be four spread evenly across the bottom surface. 

Remove the screws, then remove the 2 rubbery pieces that the screws held in place.

The Wireless charger holder for insert.stl will slide down into place from the top. The pegs on the lip should slot into the holes on the top of the insert. 

The Wireless charger insert front plate.stl then is pushed in from the front to set against the wireless charger holder. Angle the front plate so that the screw holes line up. Screw in the four screws. 

Once built, there should be a hole on the bottom right side that the cord can be run through. Slide the charge into the holding spot, being sure the uprights hold it in place. You'll notice in my pic, the right side upright broke off. The charger is still very stable without it, so it's not a big issue if it snaps. Once assembled, you just have to put the insert back into the center console, run the power cord, and you should be set. 

This test model has been in use for just around 6 months and functions great. The phone does not shake around, and the charger is steady.

Tagi